Prym Anorak Non-Sew Press Fasteners Silver 15mm - 10 pcs

If your jacket, vest or coat has lost its press studs or you need new life for the old, worn out press studs, then Prym Anorak Press Stud Silver 15mm - 10 pcs is just what you need. These press studs are silver in colour and therefore add a little spice to any piece of outerwear. At approximately 15mm in diameter, they are a very common size for press studs. You get 10 pieces in this pack with all 4 parts that go with each press stud.

Press studs may seem difficult to work with, but the technique is easy and anyone, from beginners to more experienced crafters, can easily fit press studs. Before you know it, many more push buttons will need to be replaced with newer, nicer ones to bring out your look.

Prym Anorak Push Buttons Silver 15mm - 10 pcs are made of stainless brass. This makes them durable in all kinds of weather and for all kinds of projects. The press studs are machine washable up to 95ºC and can be tumble dried up to 80ºC. They can also be ironed on medium heat and dry cleaned. There's a handy ruler on the inside of the tool so you can easily measure the spacing of your holes.

There is a step-by-step guide in the pack with assembly pictures for all three ways you can assemble Prym Anorak Press Buttons Silver 15mm - 10 pcs.

Assembly

The Prym Anorak Push Buttons Silver 15mm - 10 pcs consist of two sides that you can press together once fitted. Each side has two parts that need to be pressed together through the fabric. On the back of the packaging, in the instructions or in the video below, you can see how the 4 parts fit together and how they should sit during assembly.

You can assemble the Prym Anorak Press studs Silver 15mm - 10 pieces in three different ways. You can use pliers at the edge of your project or use a tripod in places where the pliers can't reach. You can also snap the snaps together using a hammer and the tools provided in the pack. You get a tool and 6 smaller plastic and metal parts when you buy the Prym Anorak Push Buttons Silver 15mm - 10 pcs.

When you need to make a hole in your fabric, you will need the metal rod and the plastic disc. The metal rod is inserted into the tool. Place the disc under the fabric where you want the hole to be. Then place the metal rod where the hole is and tap the tool 3-4 times with a hammer until a hole is made.

For each of the two sides of the push button, there are two parts that need to be inserted into the tool. So when you need to put a new side in the fabric, you need to swap the parts for the correct parts for the next step in the assembly. If you have any doubts about the position of the parts, you can see it in the pictures on the back of the packaging or in the video below.

Insert both tools and parts into the tool and insert the push button through your fabric. Close the tool around the fabric as shown in the video. Finally, tap the tool 3-4 times with the hammer until the parts fit together. Remove the tool because your push button is now stuck.

Repeat the whole process step by step with the other side.

If you have any doubts about the assembly of the Prym Anorak Push Buttons Silver 15mm - 10 pcs, you can watch the video below where Prym demonstrates the assembly. In the video, Prym also shows you how to use pliers for assembly. If you are interested in pliers or tripods, you can see our selection here.

EAN: 4002273903015 (4 002273 3903015)