Prym Jersey Non-Sew Press Fasteners Ring White 10mm - 10 pcs

Do you need press studs in the little sneeze bodysuit, mittens, pants, blouses, christening gown or other, then Prym Jersey Press Stud Ring White 10mm - 10 pcs just something for you. These beautiful white press studs can be used for a myriad of projects, both big and small. The buttons measure approximately 10mm in diameter and are round. The outer sides are white, while the parts to be pressed together are silver. You get 10 sets of press studs in this pack. The sets contain both top and bottom sides. Use them in children's clothes, for example, so they can easily get them on and off themselves without having to button difficult buttons.

Prym Jersey Press studs Ring White 10mm - 10 pcs are made of stainless brass. This makes them durable in all kinds of weather and for all kinds of projects. The press studs are machine washable up to 60ºC and can be tumble dried up to 80ºC. They can also be ironed on medium heat and dry cleaned. There's a handy ruler on the inside of the tool so you can easily measure the distance of your holes.

Assembly

The Prym Jersey Press Stud Ring White 10mm - 10 pcs consists of two sides which can be closed together. Each side consists of two parts that need to be pressed together on each side of the fabric before they can be used. In each side you need one of the parts with tacks. The other two parts must be used on either side so that they can be pressed together. It is therefore important that the two parts face each other when you have pressed all the parts onto the fabric.

Prym Jersey Press studs Ring White 10mm - 10 pieces can be mounted in three different ways. You can use pliers at the edges or a tripod in places where the pliers cannot reach. You can also hammer them in place with the tools provided. A tool and 2 smaller plastic parts are included in the Prym Jersey Snap Ring White 10mm - 10 pcs. The two plastic parts are inserted into the tool on either side. Place the parts for the jersey press studs in the tool as indicated on the packaging or in the video below. Close the tool around the fabric and tap the tool a few times with the hammer until the press button is seated together. Remove the tool. Your press stud is now stuck. Repeat for the other side.

If you have any doubts about the assembly of the Prym Jersey Snap Ring White 10mm - 10 pcs, you can watch the video below where Prym demonstrates the assembly. The tool has a different design in the video, but the assembly is the same. Here Prym also shows you how to use pliers for assembly. If you are interested in pliers or tripods, you can see our range here.

EAN: 4002273901110 (4 002273 3901110)